esphome:
  name: tv2
  friendly_name: tv2
  on_boot:
    - then:
      - delay: 1s
      - output.turn_off: relais
      - lambda: 'ESP_LOGD("main", "----- boot -----> Relais OFF !");'
      - output.turn_on: bouton_vert
      - output.turn_off: bouton_rouge
      - delay: 1s
      - output.turn_on: relais
      - lambda: 'ESP_LOGD("main", "----- boot -----> Relais ON !");'
      - output.turn_on: bouton_rouge

esp32:
  board: esp32-c6-devkitc-1
  variant: esp32c6
  framework:
    type: esp-idf

# Enable logging
logger:

uart:
  tx_pin: GPIO17 # Il faut les inverser !!!!
  rx_pin: GPIO16
  baud_rate: 9600
  # debug:
  #   direction: BOTH
  #   dummy_receiver: false
  #   after:
  #     delimiter: "\n"
  #   sequence:
  #     - lambda: UARTDebug::log_string(direction, bytes);
  
modbus:

output:
  - platform: gpio
    pin: GPIO1
    id: relais
  - platform: gpio
    pin: GPIO22
    id: bouton_vert
  - platform: gpio
    pin: GPIO23
    id: bouton_rouge

globals:
  - id: low_power_count
    type: int
    initial_value: '0'
  - id: from_start_count
    type: int
    initial_value: '0'
  - id: puissance_faible
    type: bool
    initial_value: 'false'

sensor:
  - platform: pzemac
    address: 4
    power:
      name: "PZEM-004T V3 Power"
      on_value: 
        then:
          - lambda: |-
              if (id(from_start_count) < 10) {
                id(from_start_count)++;
                id(bouton_rouge).turn_on();
                id(relais).turn_on();
                ESP_LOGD("main", "--> Relais ON !");
                ESP_LOGD("main", "--> Démarrage... (%d / 10)", id(from_start_count));
              } else {
                if (id(puissance_faible)) {
                  id(low_power_count)++;
                  ESP_LOGD("main", "--> Puissance faible (%d / 5)", id(low_power_count));
                }
                if (id(low_power_count) >= 5) {
                  ESP_LOGD("main", "--> TV OFF !");
                  id(relais).turn_off();
                  ESP_LOGD("main", "--> Relais OFF !");
                }              
              }
      on_value_range:
        - below: 40
          then:
            - lambda: |-
                ESP_LOGD("main", "--> Puissance faible !");
                id(puissance_faible) = true;
                id(bouton_vert).turn_off();
        - above: 40
          then: 
            - lambda: |-
                ESP_LOGD("main", "--> Puissance normale.");
                id(puissance_faible) = false;
                id(bouton_vert).turn_on();
                id(relais).turn_on();
                ESP_LOGD("main", "--> Relais ON !");
                id(low_power_count) = 0;                    
    update_interval: 5s